- Title
- Stochastic finite element model assessing length effect for unreinforced masonry walls subjected to one-way vertical bending under out-of-plane loading
- Creator
- Isfeld, Andrea C.; Stewart, Mark G.; Masia, Mark J.
- Relation
- ARC.DP180102334.DP180102334 http://purl.org/au-research/grants/arc/DP180102334
- Relation
- Engineering Structures Vol. 236, Issue 1 June 2021, no. 112115
- Publisher Link
- http://dx.doi.org/10.1016/j.engstruct.2021.112115
- Publisher
- Elsevier
- Resource Type
- journal article
- Date
- 2021
- Description
- The strength of unreinforced masonry (URM) walls subjected to one-way vertical bending under out-of-plane loading (no pre-compression) is known to be affected by the tensile bond strength. Factors such as batching, workmanship, and environmental exposure alter the strength of this bond, resulting in spatial variability for any URM assembly. In narrow wall panels a single weak joint may dictate the failure load of a masonry wall, whereas for longer walls there is higher potential for weak joints to occur and load redistribution. This paper focuses on a stochastic assessment of clay brick URM walls with spatially variable tensile bond strength subjected to uniformly distributed out-of-plane loads in one-way vertical bending and assessing the effect of wall length on the ultimate failure load. Stochastic computational modelling combining 3D non-linear Finite Element Analysis (FEA) and Monte Carlo Simulation (MCS) is used to account for bond strength variability when estimating the walls ultimate failure loads. For this assessment FEA MCS has been applied to a set of existing test data for walls 1, 2, 4, and 10 units long, by ten different masons. Models were also developed to consider walls in the intermediate length range, 7 units long, and walls outside of this range, 15 units long. For each set of simulations the peak pressure and load–displacement data was extracted and analysed, showing agreement with the results of wall test data. The panel strength is shown to increase with wall length from 1 to 4 units, then stabilize with further length increase. The variability of the failure load is shown to decrease with increasing wall length.
- Subject
- unreinforced masonry; brick wall; finite element analysis; fMonte Carlo simulation; spatial stochastic modelling
- Identifier
- http://hdl.handle.net/1959.13/1435725
- Identifier
- uon:39798
- Identifier
- ISSN:0141-0296
- Language
- eng
- Reviewed
- Hits: 605
- Visitors: 602
- Downloads: 0
| Thumbnail | File | Description | Size | Format |
|---|